Polyolefins – injection molding
Our endothermic blowing agents are predominantly used for injection molding of polyolefins and offer you the following advantages
- Weight reduction
- Avoidance of sink marks and warping
- Achieving special color and surface effects
Our application engineers look forward to providing you with qualified and targeted advice.
PRODUCT SELECTION
| Pelletized blowing agents | Decomposition temperature | Applications / properties |
|---|---|---|
| TRACEL® IM 3170 MS | ca. 170°C | high gas pressure, exothermic |
| TRACEL® IM 4201 | ca. 200°C | exothermic |
| TRACEL® IM 4215 | 185 - 220°C | finest foam structure |
| TRACEL® IM 7200 | 135 - 220°C | fine foam structure |
| TRACEL® IM 7202 ST | 135 - 220°C | coarser foam structure |
| TRACEL® IM 7215 | 185 - 220°C | finest foam structure |
| TRACEL® IMC 4200 | 135 - 220°C | finer foam structure |
| TRACEL® INC 7207 F | 135 - 220°C | finest foam structure |
| TRACEL® NC 05/200 | 135 - 220°C | against sink marks |
| TRACEL® PO 1202 | 135 - 220°C | against sink marks |
| TRACEL® PO 2201 | 135 - 220°C | fine foam structure |
| TRACEL® PO 4155 F | 135 - 220°C | fine foam structure |
| TRACEL® PP 2200 SP | 135 - 220°C | especially for PP |
| Powder blowing agents | Decomposition temperature | Applications / properties |
|---|---|---|
| TRACEL® NC 135 | 135 - 190°C | high effectiveness |
| TRACEL® NC 155 | 135 - 220°C | fine foam structure |
| TRACEL® NCS 175 | 135 - 220°C | finest foam structure |
Our product recommendations and technical advice are based on careful research and are given to the best of our knowledge, but are non-binding. They do not release the user from carrying out his own tests to determine the suitability of our products for the respective applications.